Wide bore exhaust

Well got the exhaust fitted today and it has had all the desired effects bettle throttle response and makes the landie sound a bit beefier, still no match for the rumble of a V8 but will do for now. But the throttle response was the main aim and it is excellent.

well done mate did it all go to plan then

Good one

DICKY wrote:well done mate did it all go to plan then

Unfortunatly not the route I was planning to take was too tight, the exhaust would have been too close to my clutch pipe (almost touching) didn't fancy boiling my clutch fluid on a daily basis, so it still runs under the gearbox x-member then heads straight out the back through the PTO holes in the other cross members.

Wel done mate cant wait to hear it prob if you start her up now and give her a rev i could hear it from my house

Sorry to jump tread but, how do you guys get on with mots with straight through systems? or do you have freindly mot stations

mine comes out at waist height behind the rear wheel, does have a middle silencer, removed the rear one and soon to be the middle one, passed the mot fine, its not noisy because of the turbo.

Haven't been for an MOT with it on yet, but I can't see there being any issue.

Thanks peeps straight through it is, next question is how much clearance do you need before having to go down the lines of heat shelding 1"-2"?

because i have tank at the back looking to bring it out elseware but i might be a bit tight

I have no heat sheilding on mine, will try and find pics.

Your route will probably differ slightly to mine as I was able to go through the PTO holes.

ok not a lot of clearance at all
thanks for pics

Next time you are passing by pop in by and you can have a proper look.

Will do, might be able to show you mine

How do you peeps finish whare the exhaust comes out the body? I need some ideas to finnish it off.

Devon 4x4 sell a very neat trim to finish it off nicely. Have you used flexipipe? if so where did you get it?

Looks very smart will look it up, it is flexy i used, dont think i would of got it any other way. Got the flexy from autosave in inverness have loads of difrent sizes avalable.how much do you need i prob got 2 foot or so left.

Not sure what I'm going to do with mine just yet... I'm hoping I win the rollover tonight so I can have a bespoke straight through stainless system built!

heres mine.

Al put me on to moray enginering inverness, went to see them and they are going to turn me a flange to go on, pick up this week so hopefully be on for sunday .